How to install the full-automatic saline injection machine? How to use it?

How to install the full-automatic saline injection machine? How to use it?

How to install the automatic saline injection machine?

Although the saline injection machine has been debugged before leaving the factory, due to transportation and other reasons, fasteners, transmission parts, instruments and instrument control parts still need to be checked.

1.Secure the fuselage. The bottom of the machine has4A spiral anchor. After the equipment is placed in the designated position, screw out the screw anchor counterclockwise to make the foot of the ground in complete and stable contact with the ground to ensure the stability of the body.

2.Connect the air source. There is a compressed air hose connector on the back of this machine. Make sure it is connected to a clean air source and that it is firmly connected.

3.Connect the power supply and firmly connect the power cord to the brake box.

4.Parts such as valves and pipe accessories

5.Connect the water pipe to ensure the reliable connection between the brine truck and the water pipe joint of the machine. The injection level in the brine car must not be lower than the highest point at the inlet of the water pump, otherwise it will affect the injection pressure and even damage the water pump.

automatic saline injection machine how to use?

1.First, pour the prepared juice into the truck after passing through the filter. Then push the truck into the belly of the fuselage and connect the water pump inlet pipe. Power on.

2.Check whether the machine is operating normally. Normal operation means that the conveyor belt advances when the needle is down.

3.Can be injected after normal operation. (Start slowly before injection, then start the pump) Check whether the pump is supplying liquid normally.

4.Place the meat on a conveyor belt and arrange it evenly. Do not put the meat in the gap on both sides of the chain, which will make the sprocket stuck and cannot be used.

5.During the injection process, be sure to check whether the filter screen is blocked. If clogged, clean the filter before continuing use.

6.Pay attention to check the dose frequently during injection, and supplement it in time when the amount of injection is insufficient.

7.The needle stroke, conveyor belt stroke, pressure, high speed and low speed of this machine can be adjusted according to your injection needs.

8.After injection, pour out the residual liquid, add water, start the machine cleaning. After cleaning, wipe the appearance of the machine to ensure that the machine is clean.

9.After the saline injection machine is wiped clean, check whether the needle is blocked. If it is blocked, remove the needle and clean the debris inside the needle with a fine wire. To prevent the injection effect from being affected.