Automatic palletizer manufacturers to talk about the following palletizer operation failure how to prevent

　Automatic palletizerManufacturer: Preventive measures for the operation failure of the palletizer

With the advancement of technology, the performance of the palletizer is now quite perfect, not only the palletizing efficiency is high, the palletizing effect is also very good, and even a variety of different products can be palletized at the same time, but no matter how good the product is, it cannot be perfect. During the operation, there will be some failures due to negligence or other reasons,Automatic palletizerSo it is.

In order to reduce the probability of failure of the palletizer in use, first of all, before the palletizer is officially operated, it needs to be tested. If it is a newly purchased palletizer, it naturally needs to be put into trial operation, so as to ensure the palletizer There is no problem in the trial operation before it can be officially palletized.

Secondly, according to the different products to be transported or palletized, set the parameters on the palletizer,Automatic palletizerAlthough manual operation is not required, the premise is that all parameters are set, and the settings of these parameters must be consistent with the needs of the goods to be palletized.

AlthoughAutomatic palletizerA series of operations can be completed automatically, but this product also supports manual operation. In some necessary cases, manual operation can be used to reduce the probability of failure. For example, if the length of the packing belt is insufficient, you can choose to manually remove the tape.

In addition, if you want to reduce the trouble of the palletizer during operation, you need to pay attention to many problems. If there is a problem, you need to set the code to turn off the power and find a professional to detect it. Before the problem is detected and completely resolved, Do not start again easily.

　　Automatic palletizerManufacturers: Small palletizing robot common problems and solutions

The user can check whether the bolt is loose, whether the front buckle or inner plate of the trigger is worn, tighten the bolt, pay attention to the correct position of the front buckle shaft, you can replace the front buckle or inner plate of the trigger, after the above actions are completed, test its function, if the stroke is too short, fine-tune the front buckle shaft upward, if the action is slow, fine-tune the front buckle shaft downward.

What should I do if the piston rod leaks? This is mainly because the bottom ring of the palletizing robot body is damaged and the ring needs to be replaced.

How to deal with air leakage? The user can check whether the switch valve ring, the switch seat ring is damaged, or the piston ring is damaged. If it is damaged, the ring needs to be replaced.

The above content is the common problems and solutions of small palletizing robots. I hope they can help you. If the robot has problems, you can check according to the above methods. If the problem cannot be well controlled, you can find a professional to repair it. In the process of daily use, everyone should pay attention to the daily maintenance of the robot to extend the service life of the robot.

　　Automatic palletizerManufacturer: Today, the editor will explain here. If you need to purchase palletizing machines, you can consult our company.